How set notification of channel (modbus) with value (On/Off)? now, i've configured notification template by http to send notification by telegram apps.
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hi,
I set Modbus (converting analog to digital) in sensor group and I already set down state notification. But, I configured Modbus sensor with more than one channel (example: fan (on/off), compressor (on/off), etc.). So, How I can set notification for the fan / compressor channel?
May, 2022 - Permalink
We would need to take a closer look at the sensor, in order to give some suggestions. Please open a support ticket and provide us with some screenshots of the sensor (Overview, Settings, Notification Triggers tab). You can open a support ticket by writing us a email at support@paessler.com.
Kind regards,
Sasa Ignjatovic, Tech Support Team
May, 2022 - Permalink
Hello,
Does your Modbus sensor already go into Down state when needed?
If that is the case, then you just need to configure a State Trigger in the Notification Triggers tab of the sensor.
Kind regards,
Sasa Ignjatovic, Tech Support Team
May, 2022 - Permalink