I have two Palo Alto firewalls setup in an Active\Passive configuration. I have added the OID codes to monitor the HA on both firewalls. (1.3.6.1.4.1.25461.2.1.2.1.11.0 and 1.3.6.1.4.1.25461.2.1.2.1.12.0)

The current active firewall has the sensors showing the correct data (it is active and the peer is passive) and both sensors are green.

The current passive firewall has the sensors showing the correct data (it is passive and the peer is active), but both sensors are yellow and showing a warning.

How do I correct this and or why is the the second firewall showing errors?

Article Comments

Hi there,

Please let us know which warning is displayed?


May, 2022 - Permalink

The “Top” Palo show green check marks for Node and Peer modes….
The “Bottom” Palo shows yellow warning status icons even though they Node and Peer are correct.
The “Bottom” Palo should be showing green checks as well.


May, 2022 - Permalink

In this screenshot we can see that the Sensor is in the warning state but not why. Therefore, please share the warning message.


May, 2022 - Permalink

Node HA Mode: Warning caused by lookup value 'passive' in channel 'Value' Peer HA Mode: Warning caused by lookup value 'active' in channel 'Value'


May, 2022 - Permalink

Hey Michael,
We need to ask you to open up a ticket for our Technical Support. Please use the following Ticketnumber (PAE2277107).


May, 2022 - Permalink