Monitor members of network port channel

Modified on 2025-06-10 20:23:48 +0200

We have Dell N2000 and N3000 switches and would like to monitor the members of LACP port channels. Ideally get a warning of less than 100% of members are up. Is this possible via SNMP?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Mike
Thanks for reaching us.
I'm not sure if this would be possible using DELL.
We do have a way of doing this using Cisco.
Port channels may not have a default/standard MIB implementation, so the actual solution will depend on the device's vendor. You might want to see this KB article
https://helpdesk.paessler.com/en/support/solutions/articles/73236-port-channel-monitoring

Mar, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Monitor members of network port channel

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.