SNMP Traffic status still connected when the IPSec connection is down.

Modified on 2025-06-10 20:24:16 +0200

Hello, i have problem with the SNMP Traffic sensor for monitoring our IPSec connection, but when the IPSec connection down at my firewall, the sensor is still connected.

is there any solution regarding this problem? I've also tried to re-add the sensor but the status is still connected

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Please check the settings of your SNMP Traffic sensor. Here you can select "Show down status for all disconnected states" in the "Connection Status Handling" section if you want the sensor to show an error if the interface is down.

Mar, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP Traffic status still connected when the IPSec connection is down.

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.