Solutions

Trigger on recurring error

Modified on 2025-06-10 20:27:53 +0200

Hi,

We are monitoring a few Switches where the sensors is set to trigger after 10 minutes.

We recently had an incident where they got in an offline and online loop but too quickly to trigger the alarm. There is built in redundancy to allow a switch to restart but if it repeats

Is there a sensor or a way to set up monitoring to catch this behavior and trigger a response.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

I'm afraid there is no workaround for this scenario. The only option would be to reduce the time of your trigger to get notified.

Kind regards

Felix Wiesneth - Team Tech Support

Feb, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Trigger on recurring error

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.