Monitor Huawei AR200 series router's PPPoE session

Modified on 2025-06-10 20:29:50 +0200

Hello All,

I have configured SNMPv3 in Huawei AR200 series router in PRTG. It can monitor all interfaces, CPU load, memory, uptime and all. I would like to monitor PPPoE status using PRTG. Can someone please tell me how to achieve it? Unfortunately I am not able to acquire any SNMP MIB from Huawei end so I don't OID for PPPoE if available.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Unfortunately, we do not have any prior experience with these devices. Perhaps, one of your users have any experience with this.

Kind regards,
Sasa Ignjatovic, Tech Support Team

Feb, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Monitor Huawei AR200 series router's PPPoE session

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.