Ubuntu v20 unable to monitor disk usage.

Modified on 2025-06-10 20:30:13 +0200

According to a wireshark it looks like PRTG is doing a lookup on OID:

1.3.6.1.4.1.2021.9.1.3

Doing an SNMP walk on the 1.3.6.1.4.1.2021 OID with the PRTG SNMP tester there is no 1.3.6.1.4.1.2021.9 OID tree. it goes from the 1.3.6.1.4.1.2021.4 tree then skips to 1.3.6.1.4.1.2021.10 tree.

PRTG returns error 222 on the sensor.

CPU and Memory sensors work. Only disk utilization via SNMP doesnt.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

This is correct the OID table 1.3.6.1.4.1.2021.9 is required. If these are not available, the Sensor cannot work. Therefore, please check the snmpd.conf whether it's correct configured: https://blog.paessler.com/how-to-enable-snmp-on-your-operating-system

Feb, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Ubuntu v20 unable to monitor disk usage.

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.