Prtgadmin Network Monitor
Modified on 2025-06-10 20:36:46 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi,
i would like to know if it's possible to filter a report based on ip address ?
Since i have a sensor with sniffer on , i can see all kinds of info regarding the protocols , ip addresses and so on but what i would like to do is create a report based on ip address which i'm intrested to how much www traffic was created
kind regards,
Fei
Article Comments
Hello,
you would need to use a Custom Packet Sniffer to first monitor the traffic of certain IPs. Then you can report upon this sensor (as Toplists can't be reported).
Best Regards.
Apr, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
you would need to use a Custom Packet Sniffer to first monitor the traffic of certain IPs. Then you can report upon this sensor (as Toplists can't be reported).
Best Regards.
Apr, 2011 - Permalink