Hi,
I'm looking to add my own channels to PRTG NetFlow sensor in PRTG7. I have tried following the below pages but cannot find where the "Channel Definition" box is. Where should this be visible?
Thanks,
Eoin
Were is the Channel Definition box?
Modified on 2025-06-10 20:37:34 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
the channel definition box is not available in a default netflow sensor.
It has to be a custom Netflow sensor!
Feb, 2013 - Permalink