Unable to use custom lookup for multiple sensors monitoring a device

Modified on 2025-06-10 20:40:37 +0200

The HP Comware 5510 switch has multiple PSUs. I have created multiple SNMP custom advance sensors monitoring these PSUs. I have also created a custom lookup to show the state of a HP switch power supply. However, it appears that only one SNMP custom advance sensor within the device can have a custom lookup applied to it. I noticed this when applying this custom lookup to other sensors and the lookup for the previous sensor that have this custom lookup applied got removed. How can I have multiple sensors under a device that takes this custom lookup?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Unable to use custom lookup for multiple sensors monitoring a device

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.