PRTG not listing all Nexus 5k interfaces

Modified on 2025-06-10 20:40:55 +0200

Hi Community,

I am adding nexus 5k switch to PRTG, which has 5 fex 2k switches, but PRTG does not list any of the 2k switches interfaces, so I am not able to add SNMP sensor on it. Can anyone help please?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I would suggest that you use the SNMP Tester and perform a Walk against the following OIDs:

ifTable(32bit)
walk=1.3.6.1.2.1.2.2
----
ifXTable(64bit)
walk=1.3.6.1.2.1.31.1.1
----

This way you can check what interfaces are being returned by the target device.

Kind regards,
Sasa Ignjatovic, Tech Support Team

Nov, 2021 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

PRTG not listing all Nexus 5k interfaces

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.