Hi, I would like to know if it is possible to connect several access points to a switch so that if the switch is down that there is no alert for the access point.
Thank you
Connect access points to a switch
Modified on 2025-06-10 20:45:38 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
You'll need to configure the Ping sensor of the switch as a parent object for...
Kind regards,
Stephan Linke, Tech Support Team
Feb, 2018 - Permalink