Sflow Scanning Interval 30sec Up state but Scanning Interval 10sec change unknow state but Data be normal
this problem bug ?
Senser Sflow Scanning interval problem
Modified on 2025-06-10 20:48:54 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello there,
Stay with the 30 seconds interval then, we usually do not recommend to go below 30 seconds for any sensor as it might not work properly. With flow sensors it's also differently, since flows are processed anyway in the sensor, no matter what scanning interval you choose, it only affects how often the incoming data will be "dissected" in "Live Data" tab.
Kind regards,
Erhard
Jan, 2018 - Permalink