Cannot get SNMP CPU statistics on Cisco ISR4331 router

Modified on 2025-06-10 20:50:43 +0200

Hello I cannot get SNMP CPU statistics on our Cisco ISR 4331 router. I am able to pull other info from SNMP. I have tried different oid numbers with no luck. Any help would be greatly appreciated because it work on our old 7200 cisco routers.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

You should be able to get the CPU Load via the "Cisco System Health"-Sensor, that can be found on the following site:
https://www.paessler.com/manuals/prtg/snmp_cisco_system_health_sensor

Best regards.

Jan, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Cannot get SNMP CPU statistics on Cisco ISR4331 router

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.