Solutions

DHCP sensor timeout

Modified on 2025-06-10 20:51:35 +0200

Hi Paessler,

I have a DHCP sensor on my PRTG probe. It says Timeout. How do I troubleshoot further?

Thanks,

Bjorn Dirchsen

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Bjorn,

Thank you for the KB-Post! Since DHCP is very "low level", I would recommend or encourage you to use WireShark to find out whats going on.

Otherwise, please upload screenshots of the "Overview", "Log" and the "Settings"-Tab of the DHCP Sensor to your preferred image cloud provider and link them in your reply so that we can review the sensors setup.

Best Regards,
Emec

Jan, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

DHCP sensor timeout

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.