Hello,
I want to change the alert threshold of several sensors at the same time. The parameters do not allow to change the trigger value. What the easier way to do that ?
Thanks
Change trigger value
Modified on 2025-06-10 20:51:51 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
Did you already try the Multi Edit feature? Please note that this will just work for the exact same sensor and channels, otherwise the channels will not be visible in the multi edit window.
Create a list of the sensors: "Sensors > By Type" and mark the sensors on the right side to bulk edit them. If you then click on the desired channel, you can change the limits.
Best regards, Felix
Jan, 2018 - Permalink