Hi everyone :-)

I have a little problem. We have many Cisco Switchs and i would get the interface descriptions up to date.

On our Catalyst C3560, this works perfect. But we have also some Catalyst C2960 switches. But on theese switches, it doesn't work.

I found this entry: https://helpdesk.paessler.com/en/support/solutions/articles/76000065174-update-sensor-name-when-interface-description-changes But it works only with die C3560.

Are there any way for the 2960 switches?

Best regards

Chris

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Chris,

Have you checked the "SNMP Compatibility Settings" of the Group/Devices? If so, what settings are you using there at the moment?

Best regards.


Dec, 2017 - Permalink

Hi Dariusz...

I found my problem.

I have a static group "Switch" and inside "Autodiscovery Groups" (Room1, Room2, ...)

I make the "SNMP Compatibility Settings" changes on my static group. But i forgot to checked these settings the autodiscovery groups.

Everything works fine.

But i don't find a possibility to close my post. Or post an update.

Chris


Dec, 2017 - Permalink

Hi Chris,

Good to hear, I wish you a happy new year. :)

Best regards.


Dec, 2017 - Permalink