Monitoring may be incomplete or inaccurate due to fundamental problems in your PRTG installation! Click here for more information!

397 % Delay (Interval Delay WMI) is above the error limit of 100 % Delay in Interval Delay WMI. WMI Sensors of this probe can not be scanned in their specified intervals. Try longer intervals or distribute load over probes. - 440 % Delay (Interval Delay non-WMI&SNMP) is above the error limit of 100 % Delay in Interval Delay non-WMI&SNMP. Sensors of this probe can not be scanned in their specified intervals. Try longer intervals or distribute load over probes.

Article Comments

Hello,

We will need to have a look in the log files to investigate this issue. Could you please forward a support bundle Setup > Contact Support and refer to this knowledge base article?


Jun, 2016 - Permalink

Hi,

Am getting similar kind of error after upgrading PRTG to version 17, can someone help on this.


Dec, 2017 - Permalink

Hi there,

Please proceed as Jochen wrote. Without any further log files and information about your system we are unable to troubleshoot this.

Best regards.


Dec, 2017 - Permalink