I have a PING sensor and a Windows Update sensor on a device that is a server. I only want to get a notification from the PING sensor if it ever goes down. This currently works well for me for the ping sensor. After adding a Windows Update sensor to this device it is sending an notification through the same STATE TRIGGER. How can I separate these two so only the PING sensor sends warnings?
I have 2 sensors on a device and I only want one of them to send a notification via a STATE TRIGGER
Modified on 2025-06-10 20:53:35 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Is it possible you added the notification to the device itself and not the sensor? If it's the former, the notification will be applied to all sensors of the device. The latter will only be used for the very sensor.
Kind regards,
Stephan Linke, Tech Support Team
Dec, 2017 - Permalink