I have created a partial selection of a MIB. When I Save it for PRTG Monitor all seems ok.
When I go into PRTG and try to add a sensor using the Part MIB about half of the info is missing...??
At no time did I get any error messages. :-(
Any thoughts....?
Article Comments
Hi there,
What do you mean by "Half of the info is missing"? Do you wonder why not all data that was listed in the OID-Lib is listed during the creation of the SNMP Library Sensor?
If so, then it is most likely the case the the device does not offer data for all OIDs in the OIDlib.
Best regards.
Dec, 2017 - Permalink
Hi there,
What do you mean by "Half of the info is missing"? Do you wonder why not all data that was listed in the OID-Lib is listed during the creation of the SNMP Library Sensor?
If so, then it is most likely the case the the device does not offer data for all OIDs in the OIDlib.
Best regards.
Dec, 2017 - Permalink