Solutions

Write sensor result to disk

Modified on 2025-06-10 20:54:46 +0200

Hello, I setup an SMTP sensor to "Write sensor result to disk (Filename: "Result of Sensor [ID].txt")" Where can I retreive the log file ? The folder "\Logs (Sensors)" doesn't exist on our server. Thanks and regards, Arnaud

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Arnaud,

Check the Core Server tab of the PRTG Administration Tool, the correct folder is shown at the bottom. Within this path, you'll find the sensor logs (among others) :)

Kind regards,
Stephan Linke, Tech Support Team

Dec, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Write sensor result to disk

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.