Move group or device for new remote probe

Modified on 2025-06-10 20:55:26 +0200

Hello,

When I add a new device from a remote probe, device monitoring is performed by this remote probe.

However, when I move the group between remote probes or move the device between remote probes, will the monitoring be done by the remote probe to where it was moved?

Or is it still linked to the remote probe I added (first time)?

If this is true, can I configure for monitoring works from a new remote probe?

Thank you.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

When devices/sensors are moved to a different probe, then they run under new probe. They are no more linked to the old one.

Best regards.

Dec, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Move group or device for new remote probe

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.