Is it possible to create a trigger who sends a message if a sensor goes to ok?

Modified on 2025-06-10 20:57:46 +0200

For rollouts or installations it would be fine to import a list and get a message if an triggger goes to status "ok"

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Robert,

The state trigger allows you to set a When condition clears after a notification was triggered perform no notification condition for sensors which show an up status after the initial event. This allows you to configure an according event to get notified. The Up Condition cannot be used in the default triggers except for this "condition clear" event

Best regards, Felix

Nov, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Is it possible to create a trigger who sends a message if a sensor goes to ok?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.