Under Message Tab->Binding column...is it possible to just display one or two line of messages instead of 7 or 10 per trap?
Thanks.
SNMP Trap messages
Modified on 2025-06-10 20:57:51 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you very much for the KB-Post. I'm very much afraid though, customising the table display is not possible. Sorry.
best regards
Nov, 2017 - Permalink