After uppgrading PRTG to 17.4.35.3326 all my SNMP HP System Helth sensors has error state and saying 'NULL' is not a valid integer value.
This is occurs in four different sites with the PRTG-probe installed.
Please advice.
My "SNMP HP System Helth" sensors stopped working
Modified on 2025-06-10 20:58:38 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Janne,
Please excuse the inconvenience. We will release a hotfix that addresses the SNMP issues tomorrow.
Kind regards,
Stephan Linke, Tech Support Team
Nov, 2017 - Permalink