Hello! I have just installed PRTG in my network. But I have question about chaining. Example below. I have server (called SERVER1) with PRTG server in my network. I have ipsec tunnel to another network and server in that network (called SERVER2). In this case, I can monitor SERVER2 from SERVER1. Its okay. But I have the third server (called SERVER3). And SERVER3 I can access only from SERVER2, but not from SERVER1. And the question is - can I monitor SERVER3 from SERVER1 through SERVER2? Because its impossible to grant direct access from SERVER1 to SERVER3. Thanks in advance!
Is it possible to make a chain for monitor remote network
Modified on 2025-06-10 21:00:00 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Sergey,
Installing a remote probe on server 2 is the way to go here, if you want to monitor it completely :)
Kind regards,
Stephan Linke, Tech Support Team
Nov, 2017 - Permalink