We are looking to set up PRTG to monitor alert if a Port util goes over a certain %.
Is this possible within PRTG?
Is it possible to monitor a Port util
Modified on 2025-06-10 21:00:20 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Nathan,
You can click on the gauge symbol of the channel to enter the channel settings. Here enable the
Data | Display actual values in kbit/s and enable the limits below.
Afterwards, you can add a new State Trigger to get notified as soon as the limits are exceeded.
Best regards, Felix
Nov, 2017 - Permalink