Solutions

How to Add MSA 2040?

Modified on 2025-06-10 21:00:54 +0200

Hi to all.

I would like to add my storage MSA 2040 to monitor the disks.

I already have both controllers added, but through them I only have ping, uptime, IO Traffic, eth0 traffic, mcmc traffic, sl0 traffic, FTP and HTTP.

The idea is to monitor each disk installed in the MSA, so if any disk crashs I will know right away.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

Thank you very much for your contact.

We receive this question from time to time. Unfortunately, the device does not offer disk metrics via SNMP, so please try to use the SSH SAN Sensors which use SSH instead of SNMP:

SSH SAN Logical Disk Sensor
SSH SAN System Health Sensor

Best regards,
Sebastian

Nov, 2017 - Permalink

Thank you Sebastian.

For me, problem solved.

Nov, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to Add MSA 2040?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.