Unable to propagate sensors to other devices
Modified on 2025-06-10 21:01:30 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
All I wan't to do is to select multiple devices and give them the same sensors. I have tried using templates but that only seems to work sometimes. Either it dosn't give the sensors to the devices, or it gives me this error. \
error reading data from server (http/1.1 400 Bad Request 400)
Article Comments
Hello Inxus,
- Please try to add the sensor manually to the device for which you want to perform the auto-discovery. Does that work?
- Where exactly do you receive the Bad Request 400 message? Please upload a screenshot to illustrate the issue.
- Which sensor type are you using and are you using a proxy server for the connection?
Best regards, Felix
Nov, 2017 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Inxus,
Best regards, Felix
Nov, 2017 - Permalink