Hallo, ich würde gerne das Map objekt Fehler-Sensor bearbeiten. Ziel ist es den Namen ganz vorne anzuzeigen, dann der Fehlerhafte Sensor und als letztes den Status. Wie geht das?
Mapobjekt bearbeiten
Modified on 2025-06-10 21:01:53 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hallo spela,
Um dies zu bewerkstelligen muss auf Grundlage des bestehenden Map Objekts ein Custom-Map-Objekt erstellt werden.
Bitte beachten Sie, dass Anpassungen der PRTG Objekte offiziell nicht supported ist und Änderungen möglicherweise durch zukünftige Updates nicht mehr funktionieren.
Sollten Sie trotz allem eine Änderung anstreben, prüfen Sie bitte folgende Links die den Einstieg in Customization erläutern:
Grüße,
Sebastian
Nov, 2017 - Permalink