Why Packet sniffer result in a probe different with remote probe

Modified on 2025-06-10 21:05:19 +0200

i have tried creating 2 packet sniffer in different probe, first in local probe & second in remote probe, after several hour i tried to generate historic data from both. then i got the different result. why this happen? can u explain to me? thank in advanced

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

I would recommend you send us screenshots from "Settings" tab from each sensor to support@paessler.com for further investigation.

Kind regards,

Erhard

Oct, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Why Packet sniffer result in a probe different with remote probe

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.