Dear Paessler We are working as MSP, and need control over the number of sensors for each company. We use the "Number of Sensors Limitation", but is this setting inherited to other groups below? In advance, thanks
Kind regards, Ole Laursen
Number of Sensors Limitation
Modified on 2025-06-10 21:06:45 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Ole,
The setting applies to the group and all its subgroups. See also manual page on group settings (section "NUMBER OF SENSORS LIMITATION").
Kind regards,
Erhard
Oct, 2017 - Permalink