How to execute a custom sensor script with admin right ?

Modified on 2025-06-10 21:07:43 +0200

Does exist a parameter to do it from PRTG ?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Within the sensor settings, there's a section Security Context, allowing you to run the sensor using the credentials entered in the parent device (which can be administrative of course).

Kind regards,
Stephan Linke, Tech Support Team

Oct, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to execute a custom sensor script with admin right ?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.