Solutions

Report creation

Modified on 2025-06-10 21:09:12 +0200

Hi,

I have a wan sensor monitoring traiffic, this is set up using a bandwidth sensor and a packet sniffer, when you go into the actual probe you can filter top talker and connections, can a report be ran on just these rather than creating a report to run across the full sensor ?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Chris,

With the packet sniffer sensor it's kinda similar as with the flow sensors and reporting capabilities are limited. We were working on more extended reports for flow sensors and packet sniffers, but due to the amount of data, performance was suffering, so we did decide on not providing that function for now.

Kind regards,

Erhard

Sep, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Report creation

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.