I have setup my cisco 1905 according to KB article https://helpdesk.paessler.com/en/support/solutions/articles/76000063668-do-you-have-any-configuration-tips-for-cisco-routers-and-prtg

I can then run the netflow tester NF9Test.exe on the device and I see the flow coming in with the ScrIP:# as active The templates received are 257 and 256, and I see numerous Decoded flows coming in.

I then create a netflow V9 sensor under the device but still have no Data after 10 minutes

I am doing something incorrectly? Any help would be appreciated. Thanks

Article Comments

Hello,

Thank you for the KB-Post. Can you please share the screenshots of the Netflow v9 Tester running and getting working results? Please also share a screenshot showing the full setting of the Netflow v9 Sensor in PRTG.

In case you do not want to share these in public here, you can also send the screenshots via email with reference to this KB-Post.

thank you!


Feb, 2017 - Permalink

Hi,

i have currently the same Problem here: using v5 and v9 on different Cisco Switches (Nexus and 6808xl), Port 2055 + 2056, local Firewall configured netflow.

Nflow Tester v5 and v9 Shows incoming data, but PRTG sensor does not receive data.

???

Thanks for your Support!

Jürgen


Sep, 2017 - Permalink

Hello Jürgen, please do send us screenshots from the Netflow Testers receiving data. as well as screenshots showing the full sensor settings via email to support@paessler.com with a reference to this KB-Post. Thank you.


Sep, 2017 - Permalink