Aggregate 2 different devices in only one monitoring graph

Modified on 2025-06-10 21:11:05 +0200

Hy, I'm currently running the free version of PRTG prior to deciding whether to purchase it Actually i have configure prtg that monitor 2 different devices and their interfaces with snmp traffic sensors with no problems, i would like to know if is possbile to associate 2 interfaces of two different devices to have only one monitoring graph, a sort of virtual ionterface that point the 2 different interface. Thank for your response

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Carlo,

The Sensor Factory Sensor is able to do just that :)

Kind regards,
Stephan Linke, Tech Support

Sep, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Aggregate 2 different devices in only one monitoring graph

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.