The HP ILO sensors for Physical disk(s) give sindse i updated PRTG to the latest version the warning: Warning by lookup value 'Undefined lookup value (9)' in channel 'Disk Status'

Can someone help me with a solution.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

Add the sensor one more time to the device. Does the new sensor show the error too? If not, click on the channel the message mentions to open its settings and compare in both sensors if the same lookup is being used.

Kind regards,

Erhard


Aug, 2017 - Permalink

Hello Erhard,

When i remove the sensor and after that re-add them by using autodiscover the same sensor with the same warning comes back.

in the settings pane of two sensors i see the same settings. I dont know what you mee with same lookup, but everything is the same. acept for the harddisk name.


Aug, 2017 - Permalink

I found out what you ment with lookup. And they are all the same


Aug, 2017 - Permalink

Ok, I need a few more details, I just sent you an email about it.

Kind regards,

Erhard


Aug, 2017 - Permalink