snmptrafficsensor and bandwithsensor interface unkown

Modified on 2025-06-10 21:14:45 +0200

Hi,

we have already added a new firewall in prtg and we can see different interface like (11) traffic, someone has name so we know it but other no and moreover we are seeing more interface than we have physically. We suppose this sensor use any mib file, can you tell me in order to filter these interfaces.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you for the KB-Post. Please see the following KB-Post for the OIDs the SNMP Traffic Sensors use: snmp traffic monitor OID

best regards.

Aug, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

snmptrafficsensor and bandwithsensor interface unkown

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.