How to set the speed trigger can repeat every 5mins

Modified on 2025-06-10 21:16:04 +0200

Hi PRTG community,

I am trying to add speed trigger for bandwidth management, after searching from internet and went through the manual. Only found out state trigger have repeat function. But speed trigger which is no option can be selected to repeat the notification.

Best Regards, Bowman Leong

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear bowmanleong

That is correct, only the state trigger has this option. As a kind of workaround, you could define limits to set the sensor to warning (or error) and then use the state trigger instead of the speed trigger.

Aug, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to set the speed trigger can repeat every 5mins

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.