Dear Sir, we have installed new baracuda link load balancer in our network,and we want to monitor that device with PRTG monitoring tool please explain the procedure how to configure baracuda LLD with PRTG
Thanks and regards Sagar Baigane
How to monitor Baracuda link load balancer throu prtg
Modified on 2025-06-10 21:17:01 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you very much for your KB-Post. As we do not have native Baracuda Sensors built into PRTG, please check with Baracuda, if they offer any MIB files that you can import with our MIB-Importer (https://www.paessler.com/tools/mibimporter). If so, you can monitor the load balancer with the "SNMP Library Sensor".
Here's a Knowledge Base Article that describes the setup of "SNMP Library Sensors" and there's also a video that shows how to,
best regards.
Aug, 2017 - Permalink