monitoring bandwidth usage for multiple ISPs

Modified on 2025-06-10 21:18:13 +0200

Hi,

We have 2 ISPs in house. Is there any sensor through which I can individually monitor bandwidth usage for both ISPs. I have tried sensors, with IP, Interface and Nexthop. But the results were not what I was looking for. Is there a way can monitor that.

Regards Sandeep

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Sandeep,

The only way I see would be if you have some sort of switch point in your own infrastructure, which would make it possible to differentiate which traffic went through which ISP, like traffic through router A is ISP 1 and traffic through router B is going to ISP 2 or some vlan setup. If that's not the case, then I have no idea PRTG should differentiate it.

Kind regards,

Erhard

Jul, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

monitoring bandwidth usage for multiple ISPs

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.