how to monitor site-to-site IPSEC tunnel on Cisco 1941/K9

Modified on 2025-06-10 21:18:56 +0200

we can not implement sensors for IPSEC tunnels on cisco routers , only firewalls are allowed . we need to add sensors for IPSLA & traffic utilization . your feedback whether its doable or not.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Ahmed,

Thank you very much for your kb post. Did you already tried to deploy one of the Cisco ASA VPN sensors? Even though they are not especially stated for Cisco routers, however it might be possible that the used OID's in this sensor are not exclusively for ASA firewalls.

Does this work?

Best regards,
Sebastian

Jul, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

how to monitor site-to-site IPSEC tunnel on Cisco 1941/K9

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.