Solutions

add sensor to existing devices

Modified on 2025-06-10 21:20:46 +0200

I've seen this question already asked in 2010 but there is still no solution available. if this feature is added to prtg it will spare a lot of time to add a sensor to , in our case 300 devices.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hey Ron,

Thank you for your response.

If you want to deploy a sensor or a bunch of sensors to a group of existing devices, you can use a device template.

Kind regards,
Sven

Jul, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

add sensor to existing devices

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.