Solutions

SFlow problems with HP Procurve 2810

Modified on 2025-06-10 21:22:36 +0200

Hey Guys, I have some problems getting sflow to work on a HP Procurve 2810. I think my configuration on the Switch is just fine. Sflow is enabled and sending Datagrams. But PRTG is not recieving any data. The sensor is stuck in "grey" mode. All other sensors (not sflow) are just working fine. Any thoughts what could be wrong?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear PeterKnasalla

In this case, please manually pause the Sflow sensor. Then please run the Sflow tester. Enter the device address / port and start the test. Do you get any flows there?

Jul, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SFlow problems with HP Procurve 2810

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.