Solutions

SNMP Trap Receiver can't add - cluster was remove

Modified on 2025-06-10 21:24:33 +0200

Hi,

I want add SNMP Trap Receiver sensor. I disabled cluster ability because of it but this sensor still can not be added.

To remove cluster mode I use Step 1 at link: https://helpdesk.paessler.com/en/support/solutions/articles/760000635111903-my-prtg-cluster-is-messed-up-how-can-i-start-over

Thanks for help IS

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Why would you disable the cluster for this? What actual error do you get when adding the sensor to a device?

Jun, 2015 - Permalink

You can add a the "Sensor SNMP Trap Receiver" to Root | Local Probe

instead of Root | Cluster Probe

Jun, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP Trap Receiver can't add - cluster was remove

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.