Hello,
I have a core switch with 2 Cisco 3750G that doesn't support Netflow, which is the best way to configure PRTG in order to monitoring Bandwidth, CPU usage, memory, network performance etc.
thanks
How to monitor a Cisco 3750G on PRTG without netflow ?
Modified on 2025-06-10 21:28:02 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The lack of Netflow shouldn't be a problem, there's still a lot of stuff you can monitor since this model supports SNMP. You can employ at least the following sensors:
And if that's not sufficient, you can always resort to custom sensors or MIB files from the vendor:
Best Regards,
Luciano Lingnau [Paessler Support]
May, 2017 - Permalink