Solutions

Packet Sniffer Sensor - Top IP Range Chart

Modified on 2025-06-10 21:28:23 +0200

How can I set up a Top IP Range Usage Chart on Packet Sniffer senor?

I have three IP range (192.168.11.0/24, 192168.12.0/24, 192.168.13.0/24), I would need to have the top chart for the bandwidth usage by different network.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

A method about how you only see the overall traffic generated per subnet instead of protocol, is described on the following site. Please read the guide carefully to avoid issues: https://helpdesk.paessler.com/en/support/solutions/articles/760000635116173-netflow:-capture-only-a-subnet

Best regards.

May, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Packet Sniffer Sensor - Top IP Range Chart

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.