Isn't it possible to define SNMP Custom Table Sensors in the current version? I can't find any entries concerning this sensor.
Article Comments
The code is PE248 - The OID doesn't point to a table. But in the MIB importer the OID is marked as table...
May, 2017 - Permalink
There was an issue with the SNMP Table Sensor in Version 17.1.30.1681. If you have a newer version, it's fine, if not, please update.
If the OID isn't really a table, try adding it manually into a normal SNMP Custom Sensor then.
May, 2017 - Permalink
Hello,
Thank you for the KB-Post. Which exact errors do you get? Please send some screenshots showing the exact error messages from the "Overview"-Tab. In case the sensors are not in error-state right now, you can also check the "Log" tab of the sensor, to view previous error-messages.
best regards.
May, 2017 - Permalink