On my environment, we have been change default ports for some of the server services. In that way, when we try to use a WMI Sensor from the PGRT console, we get an error indicate some issue when trying to connect with the server.

Who can I indicate in the group or in the device the custom port we are using. The WMI / Windows Credentials tab do not permit to change the password.

Article Comments

Dear auribe,

Thank you for your post.

Unfortunately, it is not possible to configure a custom WMI port, because WMI-based sensor revert to a dynamic port range, usually between 1024-5000. We have no influence in binding specific ports, I'm sorry.

Please check the Basic requirements section of this knowledge base post for further information.

Best,
Sebastian


Apr, 2017 - Permalink

Thanks for the post.

In this case, I need to open the port range 1024-5000. And what happen with RPC port, I have to use the default port 135, or it's possible to customize this port.

Regards,


Apr, 2017 - Permalink

Exactly, 1024-5000 for DCOM and 135 for the RPC server connection.

Best,
Sebastian


Apr, 2017 - Permalink