APC UPS Input Line Voltage 220V error
Modified on 2025-06-10 21:34:18 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
hi there,
when running the Sensor APC UPS Health is get's locked into a 110V version but as we are using 220V in the Netherlands the sensors fail on all our UPS'es.
how can I adjust the PRTG sensor so it will affect all of our devices (instead of manually adjusting the limits on all sensors)?
kind regards,
Ronald.
Article Comments
Hi there,
This should be adjusted in the latest version PRTG Network Monitor 17.2.30.x
Please update and see if this resolves the error.
Best regards, Felix
Apr, 2017 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
This should be adjusted in the latest version PRTG Network Monitor 17.2.30.x
Please update and see if this resolves the error.
Best regards, Felix
Apr, 2017 - Permalink